Hey, my max memory speed is only 1075mhz. I know that that my gpu the 6800xt can be tuned to a higher speed. Because i used Amd adrenalin on windows in the past. How can I increase my max memory mhz? I use fedora as my os.

And about the voltage in CoreCTRL its differently displayed. How big does the -number need to be to get to 1060mv?

  • EddyBot@feddit.de
    link
    fedilink
    arrow-up
    7
    ·
    edit-2
    11 months ago

    afaik linux and windows shows different GPU memory clock speeds but it’s basically the same (1:2 conversion)
    most likely because bigger number = better?

    my AMD 6000 cards does the same

    • Ljubi@lemmy.worldOP
      link
      fedilink
      arrow-up
      7
      ·
      11 months ago

      I think i found the answer. Windows counts the total speed including the effective bandwidth, while most Linux utilities only report the raw clock speed.

  • Jvrava9@lemmy.dbzer0.com
    link
    fedilink
    arrow-up
    3
    ·
    11 months ago

    I overclocked my RX580 recently. Here is how to do it in CoreCTRL.

    https://gitlab.com/corectrl/corectrl/-/wikis/Setup

    Currently, to have full control of your AMD GPU while using the amdgpu driver, you need to append the boot parameter amdgpu.ppfeaturemask=0xffffffff to your bootloader configuration and reboot. NOTE: The following instructions are for guidance only. Check your distribution documentation on how to add boot parameters.

    GRUB bootloader Edit the file /etc/default/grub as root and append amdgpu.ppfeaturemask=0xffffffff to GRUB_CMDLINE_LINUX_DEFAULT:

    GRUB_CMDLINE_LINUX_DEFAULT=“… amdgpu.ppfeaturemask=0xffffffff”

    NOTE: In the above example, … represent other existing parameters. Do not add … to your GRUB_CMDLINE_LINUX_DEFAULT. You should only add amdgpu.ppfeaturemask=0xffffffff. Then regenerate the bootloader configuration file with the command:

    sudo grub-mkconfig -o /boot/grub/grub.cfg

    Reboot your system. You should have more controls when you select Advanced as Performance mode where you can tweak the mhz and voltage easily.

    • Ljubi@lemmy.worldOP
      link
      fedilink
      arrow-up
      2
      ·
      11 months ago

      I did this and i can tweak the voltage and stuff. Just max memory is wrong. On amd adrenalin i was running vram 2124mhz and here only 1075mhz. And how does the voltage work in CoreCTRL i only know how to do it in amd app in mv but i dont know what -30 is.

      • Jvrava9@lemmy.dbzer0.com
        link
        fedilink
        arrow-up
        2
        ·
        11 months ago

        In CoreCTRL, you tweak the voltage for each state. -30 in your case would reduce the voltage by 30 mv in every state which is not ideal. Just deduct 30 mv in each state in CoreCTRL.

      • Eevoltic@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        1
        ·
        11 months ago

        For the 6000 series amd gpus corectrl can only offset the voltage and not control each voltage step like adrenalin can. The -30 would probably be a 30mV reduction to the gpu voltage, but it should tell you exactly what you’re doing.