I must actually revoke my statement,it seems like it is now being revived and is developed again, at a much slower pace,though.
But much better than nothing and at least security updates seem to be working.
Sorry for the misinformation, my bad, the different sources are quite misleading sometimes.
And sadly MeshCentral is pretty much death development wise, isn’t it? The main dev left Intel and now has not enough time for the project, wasn’t that the story?
Edit: it seems to be developed again, much slower,though. But better than nothing.
And this ladies and gentlemen is what is wrong with Linux and its communities.
Technological gatekeeping is THE major problem in the Linux world. You use Linux to use Linux. You intentionally do not want people that you consider “below” you to use Linux or even be present in your communities.
Most people use computers to get something done. Be it development, gaming, consuming multimedia, or just “web browsing” (which you intentionally use to degrade people “just” doing that). They do not use computers to use computers. They don’t need to and should need to. If you want to do this, good for you.
But stop trying to gatekeep people out of it. That’s just an a****** behaviour.
Cloudron is also an option. More polished than Yunohost, created by a German company. Very low rate of admin interaction required. But not for free if you need more than two Apps.
Learn ondsel (which is basically a freecad fork) first and then transfer to FreeCAD later. It’s easier to learn at first but for true woodworking FreeCAD is better - but only after you know the basics.
Sadly neither of them is remotely efficient at all when it comes to woodworking. But if you don’t care for the time it takes too much it is something to work with.
Yes,we know about your small population,but just because Karl uses Linux now,does that really matter?
Or pirate radio it and make people think it’s a new number station. Then someone will surely put it on YouTube so you can listen to it there.